That said, it's also okay to improvise a bit if your patio structure makes it hard to 100% match the placement of anchor points. If the instructions on the package say to use all the anchor points and to space them at measured intervals, do. The last thing you want is for your fantastic new misting system to fail and need to be re-installed because the full pipe could not be held up by a meager number of anchor points. The oversight here is that high-pressure water flowing through that piping and jetting out the nozzles will make your misting system much heavier when running than it is empty. After all, the piping and nozzles together are incredibly light, so you should be fine. It's easy to think that perhaps you don't need all those tiny anchor points and the effort of screwing them in. Your anchor points are usually going to be screw-in half-circles of plastic or metal that wrap around the piping and screw into the above structure. This might be the overhang of your roof, a covered patio awning, or even a decorative wooden arbor. The anchor points for your misting system are what connects them to the structure above the patio. If you are troubleshooting oversized misting droplets or puddles forming under your nozzles, low water pressure from an underpowered pump is the most likely culprit. Any lower than 500 PSI and your nozzles will start to form larger droplets which feel wet instead of misty. As a rule of thumb, great misting happens between about 5 PSI. So whether you're building a custom misting setup or your kit simply does not come with the right pump included, you'll need to choose your pump size and power carefully. And many misting owners choose to customize in ways that increase demand on their pump, without actually upgrading the pump itself. While most misting kits will come with a pump that is guaranteed to do the job with the misting pieces you have, not all kits come with parts. But to do this, you need to create the proper amount of PSI. This creates a fine wide-spread mist that will be a delight to you and your guests. Misting relies on high-pressure water running through the piping which forces water out at some velocity through the tiny holes in the nozzles. The size of your pump also matters a great deal. The good news is that if you do miss one or two joints, it will be easy to identify because of the spray or steady drip of escaping water when the system runs. If you have any skills in plumbing, use your knowledge to secure the joints. And double-check when you're securing the misting system in place, twisting each piece tightly together as you go. Every time you connect a piece, tighten it completely. The best way to make sure you don't miss anything is to make tightening an automatic part of your installation process. And you can imagine what happens when the pressurized water does start to fly. Some misting installers, in fact, forget that water will be running through the system and don't take the time to tighten anything at all. Because a misting system involves a fair number of nozzles, joints, and elbows, this can be a lot of individual pieces to tighten and it's incredibly easy to forget just one or two along the way. And with the help of today's reel of common misting installation bloopers and solutions, you can avoid all of the most common mistakes before even getting started.īy far the most common misting mistake is forgetting to tighten your joints. Fortunately, these mistakes are usually easy to spot and fix. Misting requires many pieces to be fit together in one continuous water-tight system, which means there are plenty of opportunities to make mistakes along the way. We've seen and helped out with thousands of misting installations over the years and let us tell you, if you're struggling or worried about getting confused, you're not alone. Installing a patio misting system is simple in theory, but not always so easy to do in practice.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |